Follow the basic steps listed below to create this New Year’s Arrangement.
Glue a 4”x 7” block of Sahara Dry Foam into the bottom of the New Year’s Top Hat.
Cut 30 Silver Foil Sheets to 7”x 7”
Cut 30 Purple Foil Sheets to 7”x 7”
Take one sheet of silver, find the center, and pinch together, take one sheet of purple, fine the center, and pinch together, now put the two together. Take a 4” wired floral pick and wire around where sheets are pinched together to make a tuff.
Repeat step 4 to create 30 sets of silver and purple tuffs. Set aside until needed.
Air inflated 18” HNY foil balloon, attach to the Maxi Balloon Cup.


Thread tail through either hole and pull tight.
Wrap tail 3/4"around base of cup to slot just before threaded hole.
Lay tail across to opposite slot crossing over the threaded tail. Pull down, this will force threaded tail into slot to secure the balloon
Cut Maxi Stick to 10” insert into Maxi Cup, then insert into center of floral foam.
Add foil tuffs as shown evenly around the design, by pushing wooden floral pick into the dry foam.
Finish design by adding 4 Silver Star Foil Sprays evenly around the design.
Material List

PT – 2102 HNY Top Hat
SMI – 0520 Sahara Dry Foam
WJC - 04 4” Wired Floral Picks
DF – 050pur Purple Foil Sheets
DF – 050sil Silver Foil Sheets
PRE – MCXC Maxi Cups
PRE – BSX24C 24” Maxi Sticks
Q – 67405 18” HNY Foil
CE – 030104 Silver Star Foil Sprays

Copying of images is prohibited. Property of The Balloon Room